 ULTRACAST™ 10T series is a urethane prepolymer based on polytetramethylene ether glycol and toluene diisocyanate (TDI). The product is "capped" and contains a minimum of TDI monomer. ULTRACAST™ 10T series , when reacted with MBCA, yields a urethane elastomer exhibiting good all round physical properties and excellent hydrolytic stability. The elastomers also possess outstanding low temperature performance, and resistance to degradation as a result of heat build up from dynamic flexing.
|
10TSERIES
|
ULTRACAST™
|
| 10T75D |
PTMEG 75 SHORE D |
| 10T90 |
PTMEG 90 SHORE A |
| 10T90A |
PTMEG 90 SHORE A : shorter pot life than 10T90 |
| 10T90LV |
LOWER VISCOSITY PTMEG 90 SHORE A |
| 10T95CM |
PTMEG 95 SHORE A, COMPRESSION MOULDING |
 ULTRACAST™ CL-series is a hybrid urethane prepolymer based on a combination of backbone polymers and Toluene diisocyanate (TDI). The product may be classified as a high performance material and yields elastomers of 94 - 98 Shore A when reacted with MBCA.
The backbone polymers utilised in this formulation provide the end product with good hydrolytic stability and excellent physical properties, particularly with regards to the following:
- High heat, abrasion and cut resistance
- High load bearing and resistance to compression set
- Resistance to "chunking"
| CLSERIES |
ULTRACAST™ |
| CL802 |
PTMEG HIGH PERFORMANCE -95 SHORE A |
|
